Advertisement
{
Installation
i
5 Install BKM-102 (BA beard) in the SDI
module of BKM-101C.
@ Remove the cover of the sol module
and connect the supplied connecting
cabies.
te
Remove g
PP
Pgscews
@ Insert the-BA board into the SDI
module...
- 3.00...
"Use the 30-piri
' flat cable with
the metal side
facing up.
@ Insert the 30-pin flat cable connector
inte the CN5 terminal on the BY hoard,
and secure the BA board using the
supplied 4 screws with BKM-102.
.& Connect the CN1 terminal on the BA
board to the CN3 teminal on the BV
board, and connect the CN2 terminal on
the BA board to the CN4 terminal on
the BV board, using the connecting
cables supplied with BKM-102. ="
7
e
:
CN2
apin
onnecting
vcable
Spin
connecting
cable
e Attach the cover of the SDI module
using the 8 screws removed In step @.
Contings
6 Connect the SDI module and the supplied
BB board to the monitor board.
© Connect the connector of the supplied
3-pin connecting cable to the CN10
terminal (white) on the suppiied BB
board.
;
BB board
:
[
3-pin connecting cable
CN10{white)
{type B)
@ Connect the CN9 terminal (gray) on the -
BB board to the CN303 terminal (grey}
. an the monitor board.
© Connect the 3-pin connecting cabie
(type B) to the CN505 terminal an the
monitor board.
CN9 (grey) on
the BB board
cable (type B)
' 3-pin connecting
® Connact the 12-pin connector'of the SDI
module to the CN8 terminal (white) of
the BS board,-and connect the 6-pin
connector of the SDI: module te. the
CN607 terminal {white} on the power
POE
So
3 6:pin
cNé0?
-connector
;
12-pin *
cables from the
NB {white'
SDI module
CNB
} connector
sas ya catia
:
camp.
Take care not to touch the pins of the terminais.
Advertisement
