2. Install the Deflection Yoke on the CRT neck. [Fig. 6-7]
3. Install the Lens, removed in steps 13 and 14 of Removal of the CRT. [Figs. 6-1, 6-2]
1) Position the Lens so that the Labels face the direction shown in Fig. 6-8.
2) Install the mounting screws, refer to Fig. 6-1.
4. Install the PCB-CRTs.
5. Insert the Optical Unit in the Cabinet.
6. Insert the Anode Lead Wires into the Flyback Transformer.
7. Reclamp the Lead Wires in their original position.
Deflection
Fig. 6-7
Fig. 6-8
Adjustment procedures after replacing the CRT
After replacing the CRT, perform the following adjustments.
+ CRT Cut Off, White Adjustment —
« Static Convergence Adjustment
* Dynamic Convergence Adjustment
~12-