Table of Contents
Advertisement
Removal of the Lenticular Screen and Fresnel Lens
[VS-6043]
Note: When separating the Lenticular Screen from the Fresnel Lens, pry the screens apart using a slot type screw driver, and
remove the pressure sensitive Adhesive Double Coated Tape.
1. Remove the Screen Assy. [Fig. 2-2]
2. Remove 5 screws @) retaining the Screen Holder. [Fig. 5-5]
3. Remove 20 screws © retaining the Screen Frame.
®
Screen Holder
Fig. 5-5
Installation of the Lenticular Screen and Fresnel Lens
[VS-6043]
Note: 1) Wear gloves when handling the Lenticular Screen and the Fresnel Lens. This prevents cuts and finger prints.
2) Do not place the Fresnel Lens in the sun. This can cause fire and heat related injuries.
3) Store in a dry place. High humidity causes deformation of the Lenticular Screen and Fresnel Lens. -
1. Apply Double Coated Tape(# 096Z465W10) along the top front edge of the Fresnel Lens. [Fig. 5-6]
2. Set the Fresnel Lens on the top of the Lenticular Screen and apply pressure to the top edge, to join the screens
together.
3. Install Cushion(# 622D423040) on the back of the Fresnel Lens of the Fresnel Lens at the Bottom.
4. Install Cushion(# 622D423030) on the back of the Fresnel Lens of the Fresnel Lens at the Sides.
5. Apply Double Coated Tape(# 0962465W 10) along the top front edge of the Fresnel Lens.
6. Apply Double Coated Tape(# 0962465W 10) along the top front edge of the Lenticular Screen.
Double Coated Tape
Top
Top
~~
48
5inch
———»
-
F
|
L
.
|
Pino
ee ye oe
SS
Fresnel Lens
:
'
resne
enticular
L Weeensssoao
es
Double Coated Tape
ye
465W1
:
# 096Z465W10
Busca
}
# 622D423040
0.16 inch
Bottom
Lenticular Screen
"Bottom
Fig. 5-6
Advertisement
Table of Contents
