Product Introduction - Beko VRW 80318 VB User Manual

2 Overview
2.3.1 Floor Surface Cleaning
The product is equipped with a clean water tank, dirty water tank, floor cleaning roller brush,
motors and other functional modules. Water is pumped into the floor-cleaning roller brush,
and the floor-cleaning motor makes it spin at high speed to clean surfaces. After cleaning the
floor, the dirty water is sucked by the suction motor and drawn back into the dirty water tank.
During the floor cleaning process, the level of spraying water on the cleaning roller brush can
be adjusted or cancelled.

2.4 Product Introduction

"MODE" Roller Brush Water Level and Motor Speed Adjustment Button:
•
Floor Cleaning Machine is turned on with the on/off button, the Floor cleaning roller brush
water level and motor suction speed work in the Minimum Position. This appears on the
information display.
• When the MODE button is pressed again while the product is operating in minimum mode,
The floor cleaning roller brush level and the motor suction level rise to the Maximum po-
sition. This appears on the information display. When MODE key is pressed again in Maxi-
mum position; The roller water spray level on the information screen disappears. The Water
spray is cancelled. When you cancel the water spray function of the roller brush, It is used
to extract liquid from the wet floor, sweep the damp floor by mopping and sweep the carpet
floors.
Handle On/Off Button:
• "
"
starts to operate at minimum engine speed and water spraying.
• While the product is running (2), if you press the handle on-off button again, the product
turns off by operating at high speed for about 3 seconds.
• " Floor Cleaning Roller cleaning button:
"
ted and you park the product on the charging stand and start charging, the floor cleaning
roller icon starts to flash on the display. (Before pressing the floor cleaning button on the
handle (3), empty the dirty water tank and check that the clean water tank is full.) Press the
floor cleaning roller button and start the roller cleaning process. After the cleaning is com-
pleted, the product will stop by itself, the red light will illuminate the display, and the icon will
come on, reminding you to empty the dirty water tank and fill it. This red icon will turn off
when you empty the dirty water tank and fill the clean water tank.
3-in-1 Cordless Vacuum Cleaner / User Manual
(2) When you press the handle on/off button, the product
as soon as the cleaning process is comple-
When the
11 / EN