Rear Panel - Kenwood TS-930S Instruction Manual

4.2 REAR PANEL
@KENWooS
HF TRANSCEIVER
@ re-o2ce S
WITH aUTOManS
ANTENNA TUNER UNIT
© .
milf =!
ox :
- x vifkeren Reapete ager
@ ANTENNA CONNECTOR
This SO-239 coax connector should be attached to a
suitable 50 2 antenna for transmitting and receiving.
@) GND (ground) terminal
To prevent electric shock, as well as RFI and BCI, connect
the transceiver to a good earth ground.
@) RX. ANT output switch
When using the RX. ANT terminal to feed another receiver,
place this switch to the OUT position. The TS-930S's
receiver antenna input will be disconnected.
@ RX. ANT terminal
Terminal to connect an external receiver. Signal from the
antenna in use with the TS-9308S will be output only during
reception to the external receiver.
® XVERTER (transverter) terminal
This 8 Pin DIN connector is used to interface a VHF or UHF
transverter.
= FUNCTION & FUNCTION
Ground Transverter input (RX)
Relay contro! (+on
transmit) Transverter ALC input
Ground Transverter output (TX)
X-verter ON-OFF control HF ANT output
Table 4-1 XVRTR Terminal Pin-OUTS
From RX ANT
Relay Control
(+12 V ON transmit, MAX 50 mA)
RF IN PUT
A vii Transverter
To Transverter (RECEIVE)
ON-OFF SW
From Transverter ALC
Fig. 4-1 TS-930S XVRTR Internal Wiring
@ REMOTE CONNECTOR
This connector is used to interconnect a linear amplifier or
other accessory item. See page 32 for details. Use the 7
Pin DIN plug provided for connection.
@ IF OUT jack (R)
A high-level, narrow-bandwidth 100 kHz IF output, taken
before the receiver produce detector, for scope display of
the received signal waveform (to feed an SM-220, verticie
input).
PHONE PATCH jacks
Use the IN terminal for {ranemitiing- a 6002 low im-
pedance line or audio input (phone patch SSTV, AFSK, or
other input). The OUT terminal provides 600 0 line: output
for phone patch, SSTV, AFSK or other application.
17