Table of Contents
Advertisement
The PCB is mounted in the upper part of the wired controller. Be
careful not to damage the board with the slot screwdriver.
NOTE
Fasten the backing plate of the wired controller
•
Fasten the backing plate on the wall with the 3 screws (ST3.9*25) and plugs
(Figure 3) provided.
Loom access point
•
Remove plastic knockout from the backing plate (Figure 4).
•
Create a hole in the wall to access the wall cavity for routing the loom from FCU
to controller.
Figure 4.
Rinnai
Figure 3.
Remove knockout
11
Put on a flat surface.
Be careful not to distort
the back plate of the
NOTE
wire controller by over
tightening the mounting
screws.
DRCi R32 Wired Controller OIM
Advertisement
Table of Contents
