Changing The Depth Of The Chorus Effect; Applying Reverb To The Sound; For Those Who Wish To Use Midi - Roland HP 1800e Owner's Manual

10
Changing the Depth of the
Chorus Effect
You can select from 6 different Chorus levels.
1. Hold down the CHORUS button for a few seconds until
you have confirmed that its indicator has started to flash.
2. With the CHORUS button still depressed, press the
appropriate Voice button to select the desired depth
setting.
PIANO HARPS! VIBRA- £.PIANO PIPE STRINGS CHORUS
CHORD PHONE ORGAN
GS CS) C= CS ee ee
b '
L
Provides Deepens
——— a
Ô
Applying Reverb to the Sound
While holding
You can select from 6 different Reverb levels.
1. Hold down the REVERB button for a few seconds and its
indicator will start to flash.
2. With the REVERB button stili depressed, press the appro-
priate Voice button to select the desired depth setting.
PIANO HARPSI- VIBRA-
CHORD PHONE
CE iii EC
LI
Provides Deepens
— a
v
E.PIANO REVERB
6
While holding
PIPE STRINGS
ORGAN
0000000000000 0 6 0 6 è 0 è 0 0 0600000000000 è 00 è 0 000000000000 6000000000000
For Those Who Wish To Use MIDI
Those satisfied with playing the piano by itself need not read
the following.
About MIDI...
The MIDI (Musical Instrument Digital Interface) standard
was created to provide for the exchange of performance
information among electronic musical instruments and
computers.
The MIDI Connectors
Take a look at the rear panel of your piano. You should be
able to quickly find the two MIDI sockets. These connectors
enable the piano to 'converse' with other MIDI-equipped
units. The two connectors function as follows:
e MIDI IN Connector
This connector is where messages from other MIDI-
equipped units are received, and can be likened to the
"ears" which listen to what the other instrument has to
convey.
MIDI OUT Connector
From this connector, messages are sent out to other MIDI-
equipped units. It can be likened to the "mouth" in the
ongoing dialogue between the units.
In order to enable communication between two devices,
you need to run a cable, such as shown below, between
their respective MIDI connectors.
Connecting a recorder or sequencer
such as the PR-1 or MT-200
MIDI Sequenser or Recorder
Wace suru.
T a T
ramen"