Related Manuals for Hans Grohe Axor Uno2 38040 1 Series
Summary of Contents for Hans Grohe Axor Uno2 38040 1 Series
- Page 1 EN Installation / User Instructions / Warranty FR Instructions de montage / Mode d'emploi / Garantie ES Instrucciones de montaje / Manejo / Garantía Axor Uno² 38040XX1 Axor Uno² 38222XX1...
-
Page 2: Technical Information
English Technical Information Recommended water pressure 15 - 75 psi Max. water pressure 145 psi Recommended hot water temp. 120° - 140° F* Max. hot water temp 176°F* Flow rate - lavatory 1.5 gpm Flow rate - bidet 2.2 gpm Hole size in mounting surface 1⅜" Max. depth of mounting surface 1⅝" *Please know and follow all applicable local plumbing codes when setting the temperature on the water heater. Installation Considerations • For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber. 38030XX1 • Please read over these instructions thoroughly be- fore beginning installation. Make sure that you have all tools and supplies needed to complete the installation. • Keep this booklet and the receipt (or other proof of date and place of purchase) for this product in a safe place. The receipt is required should it be necessary to request warranty parts. 38222XX1... -
Page 3: Datos Tecnicos
Français Español Données techniques Datos tecnicos Pression d’eau recommandée 15 - 75 psi Presión recomendada en servicio 15 - 75 psi Pression d’eau maximum 145 psi Presión en servicio max. 145 psi Température recommandée 120° - 140° F* Temperatura recomendada del 120� - 140� F* d'eau chaude agua caliente Température maximum d'eau chaude 176°F* Temperatura del agua caliente max. 176�F* Capacité nominale - lavatory 1.5 gpm Caudal máximo - lavatory 1.5 gpm Capacité nominale - bidet 2.2 gpm Caudal máximo - bidé 2.2 gpm Dimension du trou dans la surface de montage 1⅜ po Tamaño del orificio en la superficie de montaje 1⅜" Profondeur maximale de la surface 1⅝ po Profundidad máxima de la superficie de montaje 1⅝" de montage * Vous devez connaître et respecter tous les codes de plom- *Debe conocer y cumplir todos los códigos locales apli-... -
Page 4: Installation
English Installation Place the faucet and sealing ring on the mounting surface. Install the friction washer, metal washer, and mounting nut. Tighten the mounting nut by hand. Tighten the tensioning screws. Install the drain pull rod. Connect the hot and cold supply lines to the stops. Use two wrenches, as shown in the diagram, to prevent hose twisting. Install the drain. Turn on the water and check all connections for leaks. -
Page 5: Instalación
Français Español Installation Instalación Placez le robinet et l’anneau d’étanchéité sur la Coloque el grifo y el aro de sellado sobre la superfi- surface de montage. cie de montaje. Installez la rondelle en fibre, la rondelle métallique et Instale la arandela de fibra, la arandela metálica y l’écrou de montage. la tuerca de montaje. Serrez l’écrou de montage à la main. Apriete la tuerca de montaje con la mano. Serrez les vis de pression à l’aide d’un tournevis. Apriete los tornillos tensores con un destornillador. Installez la tirette. Instale el tirador. Connectez les tuyaux d’arrivée d’eau chaude et Conecte las mangueras de suministro de agua cali- d’eau froide aux les butées d’arrêt. ente y fría a los topes. Utilisez deux clés, tel qu’illustré. Use las dos llaves fijas como se ilustra. Assurez-vous que les tuyaux ne Assurez-vous que les tuyaux ne s’entortillent pas. s’entortillent pas. Testez le robinet. Vérifiez l’étanchéité de tous les Pruebe el grifo. Verifique todas las conexiones para raccords. - Page 6 English Install the pop-up drain Remove the plunger. Unscrew the flange from the tee. Unscrew the tailpiece from the tee. Wrap the tailpiece threads with Teflon tape. Install the tailpiece on the tee. Install the sealing gasket on the flange. Rest the flange in the sink outlet. Install the mack gasket, friction ring and retainer nut on the flange. Install the tee and tailpiece on the flange. Tighten the retainer nut. Place the plunger in the drain. Install the ball rod so that the end goes through the loop in the bottom of the plunger. Install and hand tighten the pivot ball nut. Connect the swivel connector to the end of the ball rod. Connect the swivel connector to the end of the pull rod. Test the drain. Reposition the swivel connector if necessary. Tighten the swivel connector screws.
- Page 7 Français Español Installez l’obturateur à clapet Instale el tapón elevable Retirez le plongeur. Retire el émbolo. Dévissez la collerette du raccord en T. Desenrosque la brida del tubo en “T”. Dévissez la queue du raccord en T. Desenrosque la alcachofa del tubo en “T”. Enveloppez les filets de la queue avec du ruban de Envuelva las roscas de la alcachofa con cinta de Téflon. Installez la queue sur le raccord en T. Teflon. Instale la alcachofa en el tubo en “T”. Installez le joint d’étanchéité sur la collerette. Instale la junta selladora en la brida. Déposez la collerette dans la sortie de l’évier. Apoye la brida en la salida del fregadero. Installez le joint mack, l’anneau de friction et l’écrou Instale la junta mack, el aro de fricción y la tuerca de de retenue sur la collerette. retención en la brida. Installez le raccord en T et la queue sur la collerette. Instale el tubo en “T” y la alcachofa en la brida. Serrez l’écrou de retenue. Apriete la tuerca de retención. Mettez le plongeur dans l’obturateur. Coloque el émbolo en el drenaje. Installez la tige à rotule de façon à ce que son Instale la varilla de bola de modo que el extremo extrémité passe au travers de la boucle au bas du pase por el bucle en la parte inferior del émbolo. plongeur. Instale y apriete a mano la tuerca de bola del pivote. Installez l’écrou de l’articulation à rotule et serrez-le à la main.
- Page 8 User Instructions / Instructions de service / Manejo Replacement Parts / Pièces détachées / Repuestos 95701xx0 97363xx0 96911xx0 96319000 94184000 97364xx0 38093xx0 94008000 94009000 97362xx0 97360xx0 94071001 13961000 xx = Colors / Couleurs / Acabados 00 = Chrome 82 = Brushed Nickel...
- Page 9 Cleaning Recommendation for Hansgrohe Products Modern bathroom faucets, kitchen mixers and showers consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to consider certain criteria when cleaning. At the cleaning of the fittings and showers, in principle, it must be pointed out: • Only use cleaning material which is explicitly intended for this type of application. • Never use cleaning materials, which contain hydrochloric acid, formic acid, chlorine pale lye or acetic acid, as they cause considerable damage. • Phosphorus acidic cleaners are only conditionally applicable. • Do not mix cleaning agents, unless directed by the manufacturer. • Never use cleaning materials or appliances with an abrasive effect, such as unsuitable cleaning powders, sponge pads or microfiber cloths. • Always follow the instructions on the cleaning agent package with respect to specified cleaner dosage and contact time. • The building up of calcifications has to be removed by cleaning regularly. • When using spray cleaners, spray first onto a soft cloth or sponge never directly onto the product, as drops could enter openings and gaps and cause damage.
-
Page 10: Indications Importantes
• Pour le nettoyage avec produit vaporisé liquide, en aucun cas sur la robinetterie, mais au contraire aspergé sur le chiffon (torchon, éponge) et effectuer comme cela le nettoyage, car les aérosols peuvent pénétrer dans les ouvertures et fentes de la robinetterie et peuvent provoquer des détériorations. • Après le nettoyage rincez avec suffisamment d’eau claire pour éliminer les restes de produits attachés. • L’utilisation d’appareil de nettoyage à vapeur n’est pas autorisée, car les températures importantes peuvent détériorer les produits. Indications importantes • Les produits pour le corps comme les savons liquides, les shampooings ou les gels de douche peuvent causer des détériorations. • Ici aussi on doit: Après l’utilisation rincer soigneusement les restes avec de l’eau. Conseil de nettoyage • Les deteriorations imputables à un mauvais entretien ne peuvent être pris en considération par notre garantie. • Par l’action d’un nettoyant sur les revêtements déjà endommagé il se produit une aggravation des dég�ts. des dég�ts. Recomendación de limpieza para los productos de Hansgrohe Hoy en día, las griferías de baño y de cocina así como duchas modernas se componen de materiales muy distintos para satisfacer las exigencias del mercado respecto al diseño y la funcionalidad. Para evitar daños y reclamaciones hay que... -
Page 11: Limited Consumer Warranty
Limited Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products that are purchased by a consumer in the United States or Canada after March 1, 1996, and installed in either in the United States or in Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original purchaser only. This warranty is non-transferable. WHAT IS COVERED BY THE WARRANTY The warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship as follows: Hansgrohe will replace at no charge for parts only or, at its option, replace any product or part of the product that proves defective because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be made in timely fashion, Hansgrohe may elect to refund the purchase price in exchange for the return of the product. LENGTH OF WARRANTY Replacement or repaired parts of products will be covered for the term of this warranty, as stated in the following two sentences. If you are a consumer who purchased the product for use primarily for personal, family or household purposes, this warranty extends for as long as you own the product and the home in which the product is originally installed. If you purchased the product for use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe & Commercial products, and (ii) for 5 years, with respect to Axor products. THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. - Page 12 When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid. EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OTHER OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
Need help?
Do you have a question about the Axor Uno2 38040 1 Series and is the answer not in the manual?
Questions and answers