Mains Connection - Behringer ULTRALINK PRO MX882 Quick Start Manual

12
ULTRALINK PRO MX882
ULTRALINK PRO MX882 Controls
(2) (5) (8)
(1) (3) (4) (6) (7) (9)
(10) (15) (14) (13)
(16)
Controls
(EN)
(12) (11)
The MAIN INPUT LEVEL control sets the main With the BALANCE/PAN control you can set
(1) (9)
input gain, before the signal reaches the input the balance between the left and right main
bus. In SPLIT mode, the MAIN INPUT LEVEL signals. In SPLIT mode, the main input signal is
control determines the common output level routed to the mono output, with the BALANCE
for all mono outputs. control determining the balance beween the
left and right main signal portions. In MIX
The 4-digit INPUT LEVEL meter informs you
(2)
mode, the mono inputs are mixed and routed
about the input level of the main input within
via the LEVEL control to the main outputs,
a range from -24 to +6 dB.
with the PAN controls determining the
By depressing the MAIN LINK switch you can
allocation of the mono inputs to the left and
(3)
route the MAIN INPUT signal to the MAIN OUT. right main outputs.
The MAIN OUTPUT LEVEL control adjusts

MAINS CONNECTION.

(4) (10)
the output level applied to the main outputs.
MAIN INPUTS. These are the main audio
(11)
The levels present at the six mono outputs are
inputs of your ULTRALINK PRO, available as
not affected.
balanced XLR connectors. They may feed
The 4-digit OUTPUT LEVEL meter informs the mono outputs of all channels which are
(5)
you about the output level of the main input operated in SPLIT mode.
within a range from -24 to +6 dB.
MAIN OUTPUTS. These are the main outputs,
(12)
This SPLIT/MIX switch sets the respective
available as balanced XLR connectors. They
(6)
channel to SPLITTER or MIXER mode. may be fed either by the left and right main
inputs or by any of the six mono inputs (or a
The LEVEL control determines the signal level
(7)
combination of both).
of the individual channels. In SPLIT mode,
the LEVEL control sets the output level of the MONO INPUTS (channel 1 to 4). These are
(13)
mono channels. In MIX mode, however, it the mono inputs. Connection takes place via
controls the amount of the mono channel's balanced XLR connectors.
input signal feeding into the main output
MONO OUTPUTS (channel 1 to 4). These are
(14)
section; at the same time, the level of the
the mono outputs, available as balanced
mono channel can be determined, which—
XLR connectors.
owing to the maximum gain of +15 dB—
MONO INPUTS (channel 5 to 6). These are
allows for converting, e.g., home recording
(15)
levels (-10 dBV) into studio levels (+4 dBu). the mono inputs. Connection takes place via
balanced phone jacks.
The 8-digit OUTPUT LEVEL meter informs you
(8)
about the output level of each channel within MONO OUTPUTS (channel 5 to 6). These are
(16)
a range from -24 to +18 dB. the mono outputs, available as balanced
phone jacks.
13
Quick Start Guide