Advertisement
TROUBLESHOOTING
ncorrect operations are often for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the troubie may lie in another component.
inspect the other components and electrical
appliances
being used. if the trouble cannot be rectified even after execising the checks listed below, ask your nearest
PIONEER authorized service center or your dealer to carry out repair work.
SYMPTOM
CAUSE
REMEDY
1. Disc table is not ejected when
OPEN/CLOSE is pressed.
Power cord is not properly plugged into AC wall
socket.
Power switch is not turned on.
Plug in power cord.
Turn on power switch.
2. Disc table comes out.
Disc is dirty.
The disc is not properly set on the disc table.
Moisture has condensed on parts in the player.
Disc is warped
Clean disc.
Set the disc properly.
Remove disc and let player stand for 1
to 2 hours until it is dry.
Try to alleviate the warp.
(Refer to
Symptom 7, remedy column.)
3. Remote control does not work.
4. Operation of the remote control
unit causes
the TV to operate
improperly.
The CONTROL
IN terminal on the rear panel is
connected
to pioneer projection monitor or AV
control center.
Batteries are weak.
There is an obstacle between the player and the
remote control unit.
Remote contral unit is not in a good location for
transmission.
Aim the remote
control unit at the
projection monitor or AV control center,
Replace batteries.
Remove
the obstacle
or shift the
remote control position.
Operate the remote control unit in front
of the player
Some TV sets have remote contro! functions that
operate improperly in response
to the remote
control unit of the player.
Move
the TV and the player further
apart, of cover the remote sensor of
the TV during disc playback.
36
<VRB1048>
Advertisement
