Advertisement
Direct CD
Since the picture circuit is deactivated and the interference
between signals is eliminated with the Direct CD function,
more pure sound can be reproduced.
@ When the Direct CD function is activated, the player does
not display information.
e In Direct CD mode, time for starting play becomes short
compared with that of normal play operation.
1 Press DIRECT CD on the front panel.
DIRECT.
at
2 Open the disc table.
Or
[ee]
Front panel
Ae Remote control unit
@ The disc table comes out according to the CD size.
8
3 Start play.
To exit Direct CD mode:
Press DIRECT CD again. Also, when the video part of CDV is
played, Direct CD mode is canceled automatically.
a
To play an LD:
Cancel the Direct CD mode. Otherwise, the LD cannot be set
on the disc table,
NOTE
Peak Level Search
With this function, the peak level of CD or CDV (audio part)
can easily be searched for. This is convenient for adjusting the
proper recording level.
To search for the peak level of the entire disc:
Press PEAK SEARCH on the front panel.
PEAK
SEARCH
Pa
The player scans the entire disc and searches for the peak
level.
It takes for about 1 minute and 20 seconds with 60-
minute disc. While searching, the PEAK indicator is lit on the
display.
To search for the peak level of the programmed tracks:
Program the desired tracks beforehand (page 34) and press
PEAK SEARCH.
The player scans ail of the programmed
tracks and searches for the peak level between them.
To adjust the recording level
2. Adjust the recording level on the tape deck.
e@ The output level can be adjusted with DIGITAL LEVEL
CTRL.
NOTES:
@ With some discs, the player cannot detect the proper peak
level. This is not a malfunction.
35
<VRB1048>
Advertisement
