Advertisement
Quick Links
•
I
micro
1. Analogue Volume Control
(incl.
ON/OFF)
The iTube2 can be used as straight 'pass through tube
buffer' (1 M ohm input impedance) OR as a single source
pre-amplifier with the volume control
(1
00k input
impedance).
If buffer mode has been selected, please ensure that
iTube2 is ON by turning the volume control up from the
lowest position past an audible 'click.'
2.
@+
(SET/Push-Pull/
-
)
First seen in the flagship Pro iCAN, the adjustable
Tube+ ®feature injects the 'magic of tubes' for relaxing,
yet enticing playback.
If
@+
is set to:
SET
The sound signature of a Single-Ended
Triode power amplifier.
Produces a sound parallel to classic,
low-distortion tube-based studio
equipment.
Push-Pull
The sound signature of a Push-Pull
tube power
amplifier.
Tip: There is no 'right' setting, set according to system
synergy and listener preference
.
•
I
warranty
In order to activate the warranty for this iFi
product, you must register with the iFi
website.
Component
:
Serial no
:
3.XBass+ ® for Speakers
(20Hz with+ 12dB/20Hz with+
6dB/-
)
XBass®
for Speakers is quite different to its sister
technologyXBass®
for Headphones. The former gives
audio systems adjustable levels of bass control to
enhance listening enjoyment through speakers that
have limited bass
extension.
Great care has been
taken to ensure no degradation in sound quality.
20 Hz (6dB)
For speakers missing only the
lowest bass notes (below
40Hz).
20 Hz (12dB)
For speakers missing some bass
notes (below 80Hz).
XBass+
®
switched out.
*For more details, please refer to the iFi Facebook page/iFi
website.
4. 3D Holographic+® for Speakers
(30°+/+/-
)
The latest 3D
Holographic+®
matrix for Speakers offers
something quite special; it takes high-end systems to
another level of
performance.
It was drawn from the
original ground-breaking work by Alan Blumlein, the
'father of stereo.'
First, it corrects the fundamental spatial distortion in
recordings.
Second, it increases the width of the
soundstage beyond that of the speaker placement.
30°+
This matrix adds an extra 30° to redress the
narrow placement of speakers (eg either side
of a PC monitor).
+
3D+
®
matrix is switched out of the signal path.
This matrix recreates original 'width' of the
soundstage and is the recommended DEFAULT
setting.
*For more details, please refer to iFi Facebook page/iFi
website.
Advertisement
