Preset Scan Tuning; Manual Tuning - Pioneer DEH-770 Owner's Manual

Preset Scan Tuning
This function lets you automatically monitor the stations assigned to the
preset buttons.
1. Press the button &), and the preset number @ flash.
Each station assigned to the buttons in Bank (8) will be automatically
tuned in for about eight seconds.
2. When you hear a station that you like, press button (6) again to can-
cel preset scan tuning and remain at that station.
BSM (Best Stations Memory)
This function automatically locates stronger stations and automatically
assigns their frequencies to the buttons in Bank (8), from strongest to
weakest. It comes in handy when trying to find local stations while driving.
1. Press button (2) and select a band.
2. Hold down button (4). After about two seconds, a ''beep'' will sound
to signal that the BSM search has started. At this time, '' - - - -
will flash on the display.
3. The frequency display will return once BSM search is complete, and
frequencies are assigned to buttons 1 through 6 in Bank ©).
e At the end of the BSM search, the displayed frequency is that assigned
to button [1 ] of Bank @).
e tf there are fewer than six strong stations in the area, some of the
buttons in Bank (8) will not be assigned frequencies, so they will retain
any frequencies assigned to them previously.
¢ BSM search may take as long as 30 seconds in areas where there
are few strong stations.
¢ You can cancel BSM search by pressing button (@) again.
Manual Tuning
Use manual tuning when stations are too weak to be picked up by seek
tuning.
1. Press both (+) and (—) sides of button (@) simultaneously to illuminate
"MANU" @
2. Each press of the (+) side of button @) increases the frequency
in 50 kHz steps in the FM band, 9 kHz in the MW band and 1 kHz
in the LW band. Pressing the (—) side of button @) decreases the
frequency. Holding down either side of button @) changes the frequency
at high speed.