Control Mode - Pioneer VSX-502 Operating Instructions Manual

Learning capacity and buttons that can Jearn
CONTROL MODE
button
Learning function
button
(Learning procedure]
2. Press one of the CONTROL MODE buttons.
3. Press one of the Learning function buttons.
[Operation example]
As a learning example, an_explanation follows on how to use the
CONTROL
MODE VCR 1| & | button to learn the VCR PLAY signal.
NOTE:
Be sure to place the remotes ona
stable surface such as 4 table while
doing this. Also, avoid placing near fluorescent lighting fixtures or in
direct sunlight. When programing operations, use new batteries.
2 to 5 cm (1 to 2 inches)
——_
GCOCOOLC |
sHeecococece
SOSORCEEL |
Lloooo0Coe: |
_mcocolCtctc
Place the two units on a table, separated by 2 to 5 cm (1 to 2
inches).
Memorization will not be possible if they are too close.
1. Press the LEARN button.
© All the CONTROL MODE buttons flash at random.
2. Press the VCR 1 CONTROL MODE button.
Only the VCR 1 button flashes.
3. Press the [>] button.
©The VCR 1 button goes out, and lights after about one second.
If you perform procedure 4 before the VCR 1 button lights,
correct learning is not possible, so be sure to confirm that the
button is lit.
4. Continue pressing the PLAY button on the VCR remote
control.
© When learning is completed, the VCR 1 button turns off, and all
the CONTROL MODE buttons flash at random. The VCR1 [>]
button has learned the new signal.
(VCR remote control)
Re
| aa
BD aaa
Press the PLAY button.
When it turns off,
learning has been completed.
{When learning is not possible]
NOTE:
PRESET MODE (TV, VCR 1, VCR 2)
Al
<ARBI41p >