Winch mounting kit for mercedes g 460,461,463: 2001 – 01 (12 pages)
Summary of Contents for TAUBENREUTHER 2362-00
Page 1
Tel. 09221 / 95620 Fax 09221 / 956222 e-mail: verkauf@taubenreuther.de Anbauanleitung: Kompressorplatte Mercedes Sprinter 907 Passend für Kompressoren 2-00011 & 2-0051 2362-00 Best.Nr.: 2-T0601020 Montagezeit: ca. 30 min. (ohne elektische und Luftanschlüsse) Hier sehen sie den fertig montierten Kompressor ohne Verkabelung und ohne Luftanschlüsse.
Page 3
2-00011 Kompressor platzieren und verschrauben! Place and screw the compressor! 2-0051 Kompressor platzieren und verschrauben! Place and screw the compressor!
Page 4
Distanzmuffe M6 x 30 Schraube M6 x 16 mit Scheibe und Federring Distanzmuffen verschrauben! / Screw on the spacer sleeves! Luftkanal entfernen! / Remove the air duct!
Page 5
Ausschnitt an der Dämmmatte anzeichen und ausschneiden! Mark the cut out at the Insulation mat and cut it out! Kabelclipse lösen! / Loosen the cable clips!
Page 6
Montageplatte einsetzen und mit den Schrauben M6 x 16 von unten fixieren! Insert the mounting plate and fix it with the M6 x 16 screws from below! Rechte Radhausverkleidung öffnen! Open the wheel housing cover right!
Page 7
M12 x 25 Montageplatte verschrauben! / Screw the mounting plate! Alle Schrauben festziehen und Kabelclips wieder einstecken! / Tighten all screws and push in the cable clips again!
Page 8
Luftkanal wieder montieren! / Mount the air duct again!