Entering Station Names - Onkyo TX-8511 Instruction Manual

Entering station names
ABC ~ YZ-, _.*/
CHARACTER
APR FMMUTE » TUNED «
RE 'ON STEREO
MQDE MODE
fara tlry
a ee pe ev
SPEAKERS A FM MUTE > TUNED
'ON STEREO
FM MUTE » TUNED «
ON STEREO
'SPEAKERS A
Th the we FE
PEM ES ¢§ LG
SPEAKERS A FM MUTE > TUNED 4
ON 1
APR SPEAKERS 4 FM MUTE » TUNED 4
RF STEREO ON STEREO
MQDE MQDE
Ub the kip t
LEP Es Ft
SPEAKERS A
3 = DOWN TUNING
CHARACTER
While receiving a preset FM or AM station, a maximum of 8
characters consisting of letters, numbers and some symbols
can be stored, for example to represent the station name.
European and some other models only:
If you attempt to enter characters for an FM station broad-
casting RDS information, "RDS...PS" is displayed and char-
acters cannot be entered.
Characters which can be entered:
ABCDEFGHIJKLMNOPQRSTU
VWXYZ1234567890-Ux%/
Note: u indicates a space.
As an example, assume an FM station with a frequency of
89.50 MHz has been stored in preset number 2CH of group
B and will be given the name "ONKYO".
1.Select the desired station.
(Refer to Selecting preset stations on page 17.)
2.Press the CHARACTER button on the front panel.
The frequency in the display goes off and the cursor ( _ )
flashes.
3.Continue pressing the SMNO button until '"O" is dis-
played.
With each press of the button, the character that appears
in the display changes one at a time in the following
sequence: 5 > M>N>O-55...
If a button is not pressed within one second, the cursor
automatically moves to the next position.
To delete a character, press the DIRECT TUNING button.
After the selected character is deleted, all characters to the
right of the deleted character move one space to the left.
4.Continue pressing number buttons to enter the desired
characters.
To enter N, press the SMNO button.
To enter K, press the 4JKL button.
To enter Y, press the 9YZ- button.
5.Press the CHARACTER button to store the entered
characters.
If a button is not pressed within 16 seconds, the operation
will end automatically.
e@ Press the DISPLAY button when you wish to check the
frequency while you are entering the characters.
1. Select the desired station.
(Refer to Selecting preset stations on page 17.)
2. Press the CHARACTER button.
The first character and the cursor flash alternately.
3. Press the < DOWN or UP ® TUNING button to move
the cursor below the character that you wish to change.
The cursor moves to the right when the UP » button is
pressed and moves to the left when the <4 DOWN button
is pressed.
4. Enter the desired character.
The previous character is replaced with a new character.
5. Press the CHARACTER button.
Clearing all characters
1. Select the desired station.
(Refer to Selecting preset siations on page 17.)
2. Press the CHARACTER button.
3. Hold down the MEMORY button and press the FM
MUTE/MODE button.
All characters entered for the selected station are cleared.
4. Press the CHARACTER button one more time.