Advertisement
Sanding head position: Sanding head can be positioned from
vertical to horizontal with any angle in between. Loosen 5/16"
socket head cap screws located above and below coupling (#36)
in base (#1) while holding sander head firmly. Sanding head/frame
is locked in position by squeezing bearing housing assembly against
base. When desired position is reached, tighten 5/16" cap screws to
lock in sanding head. CAUTION: SANDING HEAD IS VERY
HEAVY. SUPPORT THE SANDING HEAD WHEN LOOSING
CAP SCREWS.
PLATEN: The platen is located behind sanding belt. The platen can
Be reversed and flipped t give four sanding areas. Normal wear will
occur and platen will need to be rotated occasionally depending on usage.
Remove sanding belt and platen screws (#33) to rotate platen to new position.
NOTE: continuous sanding on the same side of platen
will result in premature platen wear and belt breakage
will occur . Move work piece to different areas of platen
to extend platen and belt life.
Work table: The worktable has a slot of mounting fixtures and or mitre gauge.
Also, two mounting holes are provided on the side of the frame (#23) to move
table to different work heights.
Note: Keep work table 1/8" from sanding belt.
Kalamazoo Industries
6856 East K Ave
Kalamazoo, MI 49048
Phone:(269) 382-2050 Fax: (269) 380-0790
www.kalamazooind.com
Instructions continued
Advertisement
