Advertisement
10-6
WARNING
"CHARGED CAPACITORS 5ON THE SERVO BOARD MAY DAMAGE THE CD
DRIVE :LECTRONIC :
The following steps have to be done when replacing the CDM mechanism:
1. Disconnect old CD drive flexfoil from printed board
2. Connect paperclip to CD drive flexfoil to short-circuit flexfoil {fig.1)
3. Short-circuit printed board with brass-sheet (4822 324 11197) plugged into the flexfoil connector (fig.2)
4.. Remove old CD drive mechanism
5. Position new CD mechanism in its studs
6. Remove short-circuit from printed board connector
7. Remove short-circuit from flexfoil of new CD drive
8, Connect new flexfoil to print connector (fig.3)
fig.1
—
fig.2
naar
- fig.3
;
|
Service Position
CS 53 189
Advertisement
