Advertisement
Sees,
you shoutd try to repair the set yourself
E225
as this will invalidate the guarantee.
22
- Do not open the set as there is & risk of
electric shock.
* |fa fault arcurs, check the points listed
below before taking the system for
repair
:
© Should any problems persist after you
fave made these checks, consult your
nearest dealer or service ceniter,
CD Player Operation
"NO DISC"
is displayed.
* The disc is inserted upside dawn.
— Place CO with printed side up.
* Moisture condensation at the fens.
Wait until lens has adjusted te normal"
four femperature,
© There is ho dis¢ in the CO tray.
— dnsertatD.
;
* The CD is dirty, badly scratched ar
warped.
— Clean or replace the CD.
* The CD lens is dirty or dusty
— See section under Maintenance.
"FIGl MGT FINALIZED' is
displayed,
* The CD-RW or CD-R disc is not properly
recorded for the use of a standard CD
player.
— fead the instruction booklet of your CB-
Rewritable or CD-Recorder on haw to
finalize a recording.
'© The CD is badly scratched
or dirty.
— Replace or clean CD.
Radio Reception
Poor radio reception
© The signal strength is tao weak.
— Adjust the antenna.
© The TV or VER is too close to the stereo
system,
— Separate the sterec system from the TV
or VER,
— Connect an external antenna for better
reception.
' Tape Deck Operation
"RECORDING
ACTIVE" is displayed.
© Arecarding is in progress.
— Stop the recarding or wait until it ts
finished.
*TRRE DUPEING ONLY" is
displayed.
© Jape dubbing is only possible in tape
mode.
— Switch source to tape made.
Recording or playback cannot be
made ar there is a decrease in aitio
level.
© Dirty lape heads, capstans or pressure
rollers.
— See section on tape deck maintenance.
¢ ~Magnetic build-up in the recard/
playback head.
— Use demagnetizing tape.
General
System does nat react when any
huttenis pressed.
"e Electrostatic discharge.
— Press STANOBY-ON to switch the
system off. Remove the AC power plug
from the wail outlet, then recannect
and switch on the system again.
No or poor sound.
* Volume is not turned up.
— Adjust VOLUME,
© The system is muted.
— Press MUTE to switch on the sound.
© The headphones are connected.
— Disconnect the headphones.
© Speakers are not connected or are
connected wrongly.
— Cheek that the speakers are connected
correctly.
Make sure that the strioped speaker
wire is clamped.
Reversed jeft and right sound.
¢ Speakers are connected wrengly.
—
Check the speaker connections and
focation.,
Lack of bass sound or apparently
imprecise physical Jacation of musical
instruments.
,
= Spoaiers are connected wrangly.
— Cheek the speaker connection for
proper phasing, red/black wires to red/
bfack terminals,
\
Remote congol has no
system.
* The distance to the system is too large.
— Reduce the distance.
« Batteries are insorted incorrectly.
— Insert the batteries with their polarities
{+/+ signs) as indicated.
* Batteries are exhausted.
— Replace the batteries.
* Wrong saurce is selected.
- Select the source (CD, TUNER, etc.}
before pressing the function button,
(PLAY, PREV/NEXT, etc.).
Timer not working.
« Timer is not switched on.
— Press CLOCK/TIMER te switch on the
timer
'
© Dubbing/recording is in progress.
— Stop dubbing/recording.
System displays features
autematically; buttons flash
continuously,
« Pemonstration mode is switched on,
— Press and hold all for § seconds to
switch off the demanstration,
ect on the
PCS 102 844
Advertisement
