Using The Vacuum Cleaner - Samsung VS20A95943N User Manual

OPERATION
❇ ❇ You cannot use the vacuum cleaner while
charging.
❇ ❇ Make sure the back of the battery is
correctly placed onto the vacuum charging
part.
❇ ❇ Check that the battery level indicator is
displayed while charging.
❇ ❇ When charging starts, the battery level
indicator turns on (red, orange, or yellow
depending on charging progress), it rises
gradually, and changes to green when the
charging is complete.
CAUTION
• Before ejecting the battery, the vacuum
must be turned off.
– If the battery is forcibly ejected while the
vacuum is operating, the vacuum may
malfunction.
• Be careful not to drop the battery. If you
do, you can injure yourself or damage the
battery.
#3 Inserting the battery
Push the battery to the end until you hear it
click.
#4 Ejecting the battery
Press the battery release button at the rear of
the handle to eject the battery.
#5 Charging the additional battery
• Charge the additional battery at the
additional battery charging slot at the
bottom of the Accessory Cradle.
– Push the battery in firmly.
❇ ❇ VS20A958*** model: To charge the battery
at the Accessory Cradle, a charger needs to
be purchased separately. (VCA-SAPA95)
14 English

Using the vacuum cleaner

#6 Control Part
❇ ❇ Before using the product, you have to
select a language for the first time. Use (+)
or (-) button to select a language and hold
the (+) button for 3 seconds to complete the
setting.
– Press and hold the (+) button for 3 seconds
while using the vacuum to enter the
language setting mode later.
❇ ❇ To set the Energy Saving mode, press and
hold the (+) button for 5 seconds while the
vacuum is on the Clean Station.
– To cancel the Energy Saving mode, press
and hold the (+) button for 5 seconds.
– The Energy Saving mode is automatically
exited if the vacuum is used.
01 Power ( ) on / off: Press the ( ) button
to start cleaning in [MID] mode.
– When the Wet Brush is assembled,
the vacuum starts cleaning in the Wet
Brush mode.
02 Suction power mode control part: You can
change the suction power mode.
– You can change the 4 steps [MIN, MID,
MAX, JET] of the suction power with the
(+) and (-) button.
NOTE
• When the vacuum is in the Wet Brush mode,
only the (+) button works.
• If the brush clings to the floor or does
not turn properly depending on the floor
material (a carpet, a mat, bedding, etc.),
adjust the suction power mode to [MIN] or
[MID].
• While using the Wet Brush, the language
setting is not supported.