Operation - Kenwood TH-415A Instruction Manual
Hide thumbs
Also See for TH-415A:
- Instruction manual (20 pages) ,
- Instruction manual (21 pages) ,
- Instruction manual (20 pages)
Table of Contents
Advertisement
@ BEEP key:
|F | then 2/BEEP
Each time these keys are pressed, the audio annunciator
will be turned ON or OFF alternately.
@ (FREQUENCY) STEP key: [F_| then 3/STEP
Each time these keys are pressed, the frequency scanning
step size will be increased 5 kHz.
Several different scan function keys and scan stop keys are
provided.
@ BAND SCAN key: [F_| then 4/BAND
@ MEMORY SCAN key: [F_|
then 5/MEMORY
@ PROGRAMMABLE BAND SCAN key: [F_|
then 6/PROGRAM
@ SEEK OPERATED SCAN key: [F_|
then 7/SEEK
@ TIME OPERATED SCAN key:
|F | then 8/TIME
@ CARRIER OPERATED SCAN key: [F_|
then 9/CARRIER
For additional information on this function refer to page 14.
@ TX. STOP key: [F_|
then M/TX. STOP
Pressing these keys will prevent accidental transmission.
To cancell this function, press these keys again.
@ KEY LOCK key: [F_] then ENTER/KEY LOCK
Depress these keys and the frequency and other settings
will remain unchanged
by keyboard operation except the
LAMP key.
To cancel this function, press these keys again.
@ FAST [¥_| key: [F _] then W/FAST
@ FAST
[4_]
key:
[F_|
then A/FAST
10
OPERATION
RECEIVE
After
power
and
antenna
connections
have
been
com-
pleted, set the switches as follows:
1. Turn the VOL control clockwise to turn on power. The
frequency on the LCD display will show the transceiver
is operating.
2. As
the
VOL
control
is
turned
clockwise,
either
background noise or a QSO will be heard.
3. To eliminate the no-signal noise turn the SQL control
clockwise.
4. Enter the desired frequency.
@ TRANSMIT
Precaution:
Check the intended transmit frequency before
operating to prevent interference
with other
stations.
If you
are
using
T.
SQ
(Tone
Squelch) press the MONITOR key to allow the
Squelch to open.
1. Simply depress the PTT switch and the
[ON AIR] in-
dicator will light.
2. Speak into the microphone.
Recommended
distance to
the microphone is approximately 2 inches (5 cm).
CAUTION:
Long transmission
or extended
operation in the 5 watt
mode might cause the rear of this transceiver to get warm.
Do not place the transceiver
where
the heat sink (rear
panel) might come in contact with plastic or vinyl surfaces.
Advertisement
Table of Contents
