Philips Walita RI6833 User Manual page 9

Problem
The light of the CALC
CLEAN button flashes and
the appliance beeps.
No steam comes out of
the soleplate, the light of
the CALC CLEAN button
flashes and the appliance
beeps.
The appliance has
switched off.
The appliance produces a
loud pumping sound.
Water droplets come out
of the soleplate.
Dirty water and impurities
come out of the soleplate.
Possible cause
You did not press the steam
trigger.
The steam function has
been disabled until you have
performed the Calc-Clean
process.
At the start of your ironing
session, the steam trigger has
not been pressed long enough.
This is the Calc-Clean reminder.
You have not done or have
not completed the Calc-Clean
process.
The auto shut-off function is
activated automatically. The
appliance enters the standby
mode if has not been used for 5
minutes and swiches off if it has
not been used for another 10
minutes.
The water tank is empty.
After the Calc-Clean process
remaining water may drip out
of the soleplate.
You have used the steam boost
function too frequently.
The Calc-Clean process has not
been completed.
Steam condenses into water in
the hose when you use steam
for the first time or have not
used it for a long time.
Impurities or chemicals present
in the water have deposited
in the steam vents and/or
soleplate.
Solution
Press and hold the steam trigger until
steam comes out.
Perform the Calc-Clean process to restore
the steam function. (see chapter 'Cleaning
and maintenance')
Press and hold the steam trigger until
steam comes out. It may take up to 30
seconds until steam comes out.
Perform the Calc-Clean after the Calc-Clean
reminder is given (see chapter 'Cleaning
and maintenance').
Perform the Calc-Clean process to enable
the steam function again (see chapter
'Cleaning and maintenance').
To activate the appliance again, press the
on/off button. The appliance starts to heat
up again.
Fill the water tank with water and press
the steam trigger until the pumping sound
becomes softer and steam comes out of
the soleplate.
Wipe the soleplate dry with a piece of
cloth. If the Calc-Clean light still flashes and
the appliance still beeps, perform the Calc-
Clean process (see chapter 'Cleaning and
maintenance').
Use the steam boost function only for
stubborn creases. It is recommended not
to use it for more than 5 times within 3
minutes.
You have to perform the Calc-Clean
process again (see chapter 'Cleaning and
maintenance').
This is normal. Hold the iron away from the
garment and press the steam trigger.Wait
until steam instead of water comes out of
the soleplate.
Perform the Calc-Clean process regularly
(see chapter 'Cleaning and maintenance').
English
11