Advertisement
HOW
TO
LOAD
THE
DISCS
{Be sure to read this. before operation)
The rack is for discs No. 1-25.
@
You can Joad up to 25 discs in each rack,
-- Gently lift the handle
» to open the hood.
4
The rack comes out.
@
The hood cannot be opened if disc is being played.
@
The hood cannot be opened for approximately 10 seconds after
playback has finished, or during disc search.
e@
8e careful not to pinch your fingers when opening and closing the
hood.
@
Open and close the hood slowly.
Load the disc into the
rack with the label
side (printed surface}
facing to the right.
Label side faces right
e@
By using the racks, you
canloada
total of 25 discs
Gently
push
the
handle
down
to
close the hood.
e@ CDs cannot be played if
the hood is open.
@
ifadiscis inserted with its label side facing to the lett, it cannot be
played back. Be sure to load all discs with their label sides facing
to the right.
AWARNING:
Do not put
your hand, or any other
objects inside the rack.
-
x
Do not put anything other than CDs inside the rack.
Do not use adapters for 8-cm (3-in.} CDs.
Load only one disc into each disc slot.
Inserting an 8-cm (3-in.}CDs in between two 12-cm (5-in.)CDs, will
make it difficult to remove the 8-cm (3-in.) CD.
We recommend inserting 12-cm (5-in.)CDs starting from the right
side and 8-cm {3-in.} CDs starting from the left side of the rack.
@
The unit will not operate if the hood is open. Be sure to close the
hood before attempting any operations.
To remove the discs...
'YY Open the hood when playback has stopped
J Remove the disc from the rack.
8
<PRB1252>
En
@
The hood cannot be opened if the rack is currently playing a disc,
during disc search, or during the first 10 seconds after playback
has finished
lf you try to open the hood in one of the previous situations,
"LOCK" will flash in the display. Close the hood immediately and
wait for
"LOCK" to go out from the display before opening the
hood.
Playback will stop if you open the hood for longer than 2 seconds
when "LOCK" is flashing.
@
Be sure to remove all discs from the rack, set the STANDBY/ON
switch to off, and unplug the power cord before moving the unit.
Advertisement
