Panasonic Omnivision PV-V4540 Operating Instructions Manual page 6

OneTimeVCR Setup
When VCR is turned on the first time, Process of Setup
setup mode is entered automatically. coeg
Se >
Turn the TV and VCR on.
Press POWER".
Set TV Channel to CH 3.
* lf using AV Cable connection, set TV
to Video instead of channel. (See
connection a) on page 4.)
2 Display SELECT LANGUAGE.
This display appears for first time setup
only.
Select the language.
SELECT LANGUAGE
PUSH CH à: ENGLISH for English
OPRIMIR CH Y : ESPANOL
APP. VCR/TV : FRANCAIS for Spanish
(ESPANOL)
TO CHANGE VERS OUTPUT | į EP
AS IE eee tor French
£ (FRANCAIS)
X) Press ACTION g
IF YOU PUSH ACTION KEY,
VCR' S OUTPUT CH SWITCHES
TO CH 4.
{Y Press ACTION
ener TUNE YOUR TV TO
CH 4.
GI EJECT LIGHT When using connection b)
(see page 4), tune TV to VCR's
output channel.
lf there is beat or noise on CH3,
change VCR's output channel to CH4
by pressing ACTION twice.
* Always tune TV to this channel to monitor the VCR.
* If you used audio/video jack connection, tune the TV to its video input.
After 3 seconds
* If wrong language is set, do "Reset All VCR Memory Functions" E
steps on page 36.
4 v ¿STOP
ETO Select hookup.
u o
VCR» »
VCRPTV to select.
2) Press >
to set,
SELECT:A Y KEY
SET ¿> KEY
END ¿ACTION KEY
« If you selected "CABLE/ DSS BOX > VCR P TV," continue with step 4
and only the cable box output channe! will be placed in memory.
If not, go to step 6.
output channel.
CABLE /DSS, BOX OUTPUT CH 1) Press AW
cr to select.
SELECT: 4 Y KEY
SET '4 > KEY 2) Press >
END ACTION KEY to enter.
e If necessary, refer to cable box manual.
» If you used Audio/ Video jack connection to cable box, set "VIDEO OUT".
Turn on cable box and set it to PBS
channel in your time zone.
e If you use DSS receiver, it must be turned off.
6 For assistance, call 1-800-211-PANA(7262).