Panasonic Omnivision PV-V4540 Operating Instructions Manual page 17

l INPUT SEARCH or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
Auto VCR Plus+ System OS of aan,
Channel Setup (Part 2)
[Connection|—> | Setup | =>
Before you perform the following steps, you should have:
«completed "Auto VCR Plus+ System Channel
gramming
Setup (Part 1)" on page 16.
eleft VCR off overnight, and turned it back on after SELECT/
9:00 AM the next day. SET
A ¡PLAY
If channel updating was If VCR could not Y STOP
successful... distinguish channel map... <:REW
VCR Plus+ CH SET UP VCR Plus+ CH SET UP > FF
VCR Plus+ CH SET PLEASE SELECT
COMPLETED VCR Plus+ CHANNEL
{ ACTION
END ACTION
KEY NEXT
:ACTION KEY
3
Exit this mode. Display SELECT ADD/
Press
VCR Plus+ CH.
DELETE
ACTION. 1) Press
ACTION
O to display.
2) Continue
with step 2.
Select channel map
rea, | for your area.
1) Press AY
<
12 13 14
To Change or Update Auto VCR
Plus+ System Channel Setup
(E.g. you selected the wrong channel map, or your
VCR Plus+ CH SET UP End Setup. Ap cada Channels
PLEASE LEAVE VCR OFF Press a Do "Auto VCR Plus+ System Channel
(OVERNIGHT) A ACTION. Setup (Part 1)" steps 1-4 on page 16.
VCR Plus+ CH SET UP
i Make sure to leave VCR off
ENDE Se ON RET
(overnight.) If controllable,
A
SA
leave your cable box on.
f SELECT:A Y KEY
Channel map will be updated overnight SET
If it was successful, "VCR Plus+ CH SET COMPLETED" ENO ¡ACTION KEY
appears on screen. And then, press ACTION to exit. bPress AV to select UPDATE VCR Plus+
or SELECT VCR Plus+ CH, then press P.
C If you selected UPDATE VCR Plus+ CH
perform steps 5~7 in the "Auto VCR
Plus+ System Channel Setup (Part 1)"
section on page 16.
l If you selected SELECT VCR Plus+ CH,
If Auto Setup fails, do "Manual VCR Plus+ System perform steps 2~3 in the "Auto VCR
Channel Setup" section on page 18. Plus+ System Channel Setup (Part 2)"
section on this page.
Repeat these steps as necessary.
=
3
D
=
Bs)
D
O
e]
-
Q,
J
(Q
€
N,
=
(0
<
O
y
D
=
Y
+
oy
<
m
=
D
=