Panasonic Omnivision PV-V4540 Operating Instructions Manual page 5

1 Between ANT. and VCR
Ø Case 1: Twin Lead Cable Only
To VCR Terminal
From Antenna
300-75 ohm
Transformer
(Flat) Twin Lead (fot supplied)
300 Ohm Cable
E Case 2: Twin Lead & Coaxial Cables
==
UHF/VHF Band Mixer
(not supplied)
(Round) 75 Ohm
coaxial Cable
To VCR Terminal
E Case 3: Two Twin Lead Cables
E
UHF/VHF Band Mixer
(not supplied)
300-75 ohm
Transformer
(not supplied)
To VCR Terminal
* If your TV has both post and plug-type
VHF terminals, the post connection is
recommended to minimize signal joss.
Note to CABLE system installer:
This reminder is provided to call the CABLE system installers
attention to Articte 820-40 of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides guidelines for proper
grounding and, in particutar, specifies that the cable ground shall
be connected to the grounding system of the building, as close to
the point of cable entry as practical.
2 Between VCR and TV
@ Case 1: Screw & Plug Type Terminal
UHF/VHF Band
Separator
(not supplied)
RF Coaxial Cable
E Case 2: Screw Type Terminal
75-300 ohm
Transformer
(not supplied)
UHF/VHF Band TV
Separator
(not supplied)
E Case 4: Complex TV Terminal
TERMINALS ON BACK OF TV SET
Split out -
ANT1
ANT2
» Connect to one of the ANT terminals and
select the same antenna number on the TV. J
FCC Waming: Any unauthorized changes or modifications
to this equipment would void the user's authority to operate.
U
D
v,
O
2
O
5
5
D
O
ot.
e)
=