Advertisement
POR INSTRUCCIONES EN |
The easiest, most basic operation possible with your VCR is tape playback. Previously-recorded signals on a video tape are read by
your VCR and displayed on your TV just like a TV program.
4 Press SET or the Digit ies to
POWER ON;
input the Guide Channel
SELECT CHANNEL
numiber (as shown in TV
f
2
3 OR 4 (OR AV MODE)
listing or this manual), and
POWER ON:
1 Insert. a cassette with its window side up, and label side
then press SELECT.
SELECT CHANNEL
facing you. Press gradually on the middle of the cassette
3 OR 4 (OR AV MODE)
until the VCR pulls the cassette in.
™@ The VCR power will come on automaticaily.
™ The counter will be resct'to "0 00m 00s" automatically.
@If the safety tab on the cassette is absent, playback will
start automatically.
SHUTTLE
If you don't use an external
Cable Box...
GUIDE CHANNEL SET
5 Press SET or the Digit keys to
GUIDE CH 2VeRoH
.
input the channel number your
= | .
Pata
VCR receives the station on,
ZN
and then press SELECT.
PRESS FOT, SET «/-, OIG
@ If there are other GUIDE CH
press (MENU) TO END
numbers which don't match
with the VCR-CH numbers, input the changes by repeating
Sa
ee
steps 4 ~'5.
a.
ff you use an external Cable Box...
Press REW to rewind the tape.
5 Press SET or the Digit keys.
CH-I+
7
6
4
to input the channel number your Cable Box receives the
5 Press FF to fast-forward the tape.
® Press STOP to stop the tape.
To rewind or fast-forward the tape using the VCR's control,
turn the SHUTTLE ring fully to the corresponding direction,
and release at
station on, and then press SELECT.
W:If there are other GUIDE CH numbers which don't match
with the CABLE CH numbers, input the changes by
repeating steps 4 ~ 5.
Press MENU once to go back
to the Tuner Set menu.
Press SET to move the cursor
to "GUIDE CHANNEL MAP",
and then press SELECT.
"A screen with GUIDE CH
numbers (in ascending order)
with their corresponding
6
6 Press the VCR's STOP/EJECT button again,
GUIDE CHANNEL SET
#GUIDE CHANNEL MAP
PRESS
(SELECT, SET +/+)
PRESS (MENU) T0 END
To adjust:tracking manually
This overrides your VCR's automatic tracking.
-
During Playback...
VCR_CH numbers will be
:
displayed. Check to make
CH/SET
(1) Press the VCR's CH(annel) +/— buttons simultaneously to
sure your entries are correct.
—/+
cancel auto tracking.
;
During Slow...
(1). Simply press CH + or — to adjust tracking.
8 Press MENU 3 as many times as necessary to exit.
EN-18
EN-19
|
Advertisement
