Table of Contents
Advertisement
How to Attach the External Antenna Ofer atat=rea col am (=10]
9) ei 1-10)
woeemnnmin tee
E.
4 Loosen the screws on the antonio connector.
300-ohm twin
lead cable
ip Fit the 300-ohm twin lead cable on the UHF antenna under the
ee ahe
==. - screws on antenna conmecier: |
a toh Ce) enacn the EAC-66 U/V _— Separator/Mixer (not supplied)
3 Tighten ~~ screws again.
VHF/UHF IN
300-ohm twin lead
Loosen the ecrews on the uw pee separator/mixer.
Fit the 300-ohm twin lead cable on the UHF antenna under the
"A Connect the UV band eeparatorhnixer to the VHF/UHF IN on the
VCR.
is ir
Setting the RF Unit
ee
he
Why this setting is necessary
ina ti
Your TV receiver must be set to receive the signal from your
weit
|
VCR. To get the proper RF signal, set the RF UNIT sefector
switch on the rear panel of the VCR. If channel 4 is active in
your area, set the switch to 3 CH, and vice-versa. If you
connect a color monitor or a TV equipped with video/audio
input jacks, you do not need to make this setting.
1 Set the RF UNIT at the rear of the VCR to 3 CH or 4
CH, whichever is not active in your area.
2 Press POWER.
The indicator will light.
3 Press ANT TV/VTR so that the VTR indicator lights.
4 Check that the TUNER indicator appears in the
display window, then select an active channel in your
varie:
area by pressing CHANNEL +/-.
— —
5 turn on the TV and set the TV to the channel selected
am eh
ede
=
==
The TV program selectd on the VCR will appear on the
screen.
|
Your TV is now tuned to the VCR. Whenever you use the
|
VCR, set the TV to the channel selected above.
Note
For details about TV channel adjustment, see the instruction manual of the TV.
Getting Started l { 3
AL e
Gujgeuu
|
Advertisement
Table of Contents
