Table of Contents
Advertisement
E Connecting a TV
In order to watch the playback picture on the TV screen and
to receive TV programs on this VCR, the VCR and the TV
receiver must be connected property. The connection
between the two units varies depending upon the tape of TV
receiver and antenna that you have. We will show you some
typical ways to make connections. Before operating the unit,
classify your TV for a connection by using the flow chart
below, then make the correct connections.
suhash@l Ol alsiol.am (o)0] am M'an a0) am Orolelalsiendiolars
SYeacelasmmanrsh qiaremoxe)alalsyen dlelal-vnelalcol ancalsan (olicoh pare
points
© Turn off the power to the VCR and the TV.
© Do not connect the AC power cords until all of the
connections
are completed.
®@ Make connections firmly. Loose connections may cause
distortion.
picture
i
© if your TV does not match the tiwee examples below...
Consult your nearest Sony dealer or qualified technician.
if your TV does not have video and audio input jacks
Check the antenna terminais on your TV
Go through "Connection
Examples 1 to 4" on page 7 to 9 to find the
connections,
appropriate
For a cable TV connection, go to "Connection Example 5 on page 10".
Then read "Setting the RF Unit" to view the playback picture of the VCR on
the TV on page 13.
Caution
Connections between the recorder VHF/UHF OUT connector and the antenna
terminals of a TV receiver should be made only as shown in the instructions.
Failure to do so may result in operation that violates the regulations of the
Federal Communications Commission regarding the use and operation of
tt devices. Never connect the output of the recorder to an antenna or make
simultaneous (parallel) antenna and recorder connections
at the antenna
terminals
of your receiver.
Ble
Advertisement
Table of Contents
