Table of Contents
Advertisement
Operating the appliance
en
Reloading the laundry
When the programme has started, the
laundry can be reloaded or taken out as
required.
Touch the A Start/Reload button. The
washer dryer checks whether reloading is
possible.
Notes
If there is a high water level, high
■
temperature or if the drum is rotating,
the door remains locked for safety
reasons and reloading is not possible.
If the following is indicated on the
display panel:
Õ is lit ~ Reloading is not possible.
To continue the programme, select the
A Start/Reload button.
Do not open the door until the door
■
lock symbol Õ goes out.
Do not leave door open for
■
a prolonged period – water could run
out of the laundry.
The reloading function cannot be
■
activated during the drying phase.
Changing the programme
If you have started the wrong programme
by mistake, you can change the
programme as follows:
Select A Start/Reload.
1.
Select another programme. If required,
2.
adjust the default settings and/or
select additional functions.
Select A Start/Reload. The new
3.
programme starts from the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
Select A Start/Reload.
1.
To cool down laundry: Select Rinse
2.
O.
Select A Start/Reload.
3.
For programmes at low temperature:
Select A Start/Reload.
1.
Select Spin/Drain 0/[.
2.
Select A Start/Reload.
3.
18
For drying programmes:
Select Intensive Dry 5 or Gentle
1.
Dry ‰.
Touch button 5 Dry and set drying
2.
time to 15 minutes.
Select A Start/Reload.
3.
End of the programme
End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
A Start/Reload button to start the final
drain/spin cycle.
Notes
The programme continues by
■
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
If only the water is to be pumped out,
■
approx. 1 minute after the
programme starts, touch the A
Start/Reloadbutton before the spin
cycle starts. The programme is
interrupted and the door lock is
released. The laundry can be
removed.
If Hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
Wrinkle guard process starts after
■
drying process is finished to prevent
laundry getting wrinkle if you do not
take laundry out in time. The process
lasts about 30 minutes. 0:00 will be
displayed in time display and o
symbol will be displayed as the
status symbol. You can press any
button or rotate the programme
selector to another position to
terminate this process, then the door
will be released and laundry can be
taken out.
Advertisement
Table of Contents
