Childproof Lock; Reloading The Laundry; Changing The Programme; Interrupting Or Ending The Programme - Bosch WVG30460ME Instruction Manual And Installation Instructions

Operating the appliance
en

Childproof lock

You can secure the washer dryer to
prevent the set functions from being
changed inadvertently. To do this,
activate the childproof lock when the
programme has started.
Activating/deactivating: Touch and hold
the buttons 0 rpm and û Finish in for
approx. 3 seconds. The symbol w is
indicated in the display. If the button
signal is activated, an acoustic signal
sounds.
w lights up: The childproof lock is
■
activated.
w flashes: The childproof lock is
■
active and the programme selector
has been adjusted. To prevent the
w symbol from flashing, reset the
programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. If this is the case,
deactivate the childproof lock before the
programme starts and, if required, re-
activate after the programme starts.

Reloading the laundry

When the programme has started, the
laundry can be reloaded or taken out as
required.
Touch the Start/Reload button. The
washer dryer checks whether reloading
is possible.
18
Notes
If there is a high water level, high
■
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ is lit ~ Reloading is not
possible. To continue the
programme, select the I Start/
Reload button.
Do not open the door until the door
■
lock symbol Õ goes out.
Do not leave door open for
■
a prolonged period – water could
run out of the laundry.
The reloading function cannot be
■
activated during the drying phase.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select I Start/Reload .
1.
Select another programme. If
2.
required, adjust the default settings
and/or select additional functions.
Select I Start/Reload . The new
3.
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
Select A Start/Reload .
1.
To cool down laundry: Select Rinse
2.
O.
Select A Start/Reload .
3.
For programmes at low temperature:
Select A Start/Reload .
1.
Select Spin/Empty 0/[.
2.
Select A Start/Reload .
3.