Table of Contents
Advertisement
Notes
The programme continues by
■
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
If only the water is to be pumped out,
■
approx. 1 minute after the
programme starts, touch the A
Start/Reload button before the spin
cycle starts. The programme is
interrupted and the door lock is
released. The laundry can be
removed.
If Hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
Wrinkle guard process starts after
■
drying process is finished to prevent
laundry getting wrinkle if you do not
take laundry out in time. The process
lasts about 30 minutes. 0:00 will be
displayed in time display and Ó/o
symbol will be displayed as the
status symbol. You can press any
button or rotate the programme
selector to another position to
terminate this process, then the door
will be released and laundry can be
taken out.
Operating the appliance
After washing/drying
Open the door and remove the
1.
laundry.
Turn the programme selector to Off.
2.
The appliance is switched off.
Turn off the tap.
3.
Not required for Aqua-Stop models.
Notes
Do not leave any items of laundry in
■
the drum. In the next wash they may
shrink or discolour another item.
Remove any foreign objects from
■
the drum and the rubber seal – risk
of rust.
Leave the detergent drawer and
■
door open so that residual water can
evaporate.
Always remove the laundry.
■
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for the unlocking device.
When the display panel has gone
■
out at the end of the programme,
energy-saving mode is active. To
activate the display again, select any
button.
en
31
Advertisement
Table of Contents
