Toro 23126 Manual page 11

For traction units with serial numbers 4000000000 and up:
A. Under the control panel, remove the traction unit harness connector from the ignition switch
1. Ignition switch
B. Plug the traction unit harness connector into the fit-up kit harness connector
C. Plug the other fit-up kit harness connector into the ignition switch
1. Ignition switch
2. Fit-up kit harness connector (to ignition switch)
6. Below the ignition switch, under the hood, connect the 2 light kit connections
7. Secure the harness to the traction unit wire harness with 2 cable ties as shown in
Figure 9
2. Traction unit harness connector
Figure 10
3. Fit-up kit harness connector (to traction unit harness ignition
terminal)
4. Traction unit harness connector (to fit-up kit harness
connector)
9
(Figure 10).
(Figure 10).
(Figure 11).
Figure 11.
(Figure 9).
g355402
g355403