Toro 23126 Manual page 15

5
Installing the Heat Shield
Parts needed for this procedure:
1 Heat shield
Procedure
1. Unplug the wire-harness connector
from the seat.
Figure 16
1. Seat
2. Seat mount
3. Washer
4. Knob
2. Remove the hardware that secures the seat to
the seat mount (Figure
3. Position the spacers, heat shield, and seat on
the seat mount (Figure
(Figure 16)
g377873
5. Wire-harness connector
6. Bolt
7. Spacer
16) and remove the seat.
17).
1. Heat shield
2. Seat
4. Install the wire-harness connector
to the seat.
5. Use the previously removed hardware
16) to secure the seat and heat shield to the
seat mount.
6
Installing the
Hook-and-Loop Strap
Parts needed for this procedure:
1 Hook-and-loop strap (20 inches x 1 inch)
Procedure
1. Turn the battery-disconnect switch to the O
position and start the engine.
13
Figure 17
3. Spacer
4. Seat mount
(Figure
(Figure
g377887
16)
N