Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Mobile Devices C4D-4G4EUWBT V6+
Summary of Contents for Mobile Devices C4D-4G4EUWBT V6+
- Page 1 C4D-4G4EUWBT_V6+ - INSTALLATION GUIDE V 1.4 20/12/2017...
-
Page 2: Table Of Contents
Table of contents Preface......................... 3 Warnings and notices ....................3 RF Exposure Information (SAR) ..................3 1. Hardware features ....................4 2. Hardware description....................5 2.1. External view ...................... 5 2.2. Internal view .......................5 2.3 OBD connector pin out ....................6 * Please read warnings section at the beginning of the installation guide ......6 2.4 OBD adapter wires ......................6 3. -
Page 3: Preface
The information contained in this installation guide is subject to changes in order to improve the reliability, design or features without prior notice. Mobile Devices Ingénierie reserves the right to make changes in the content without obligation to notify any person or organisation of such changes or improvements. Mobile Devices Ingénierie can in no event be held liable for technical or editorial errors or omissions herein, nor for... -
Page 4: Hardware Features
1. Hardware features OBD Dongle Performance Processor Cortex A5 - 500MHz 128 Mbytes NAND Flash 256 Mbytes Power supply External power supply range 8-18V External voltage ● measurement Li-pol battery 270mA.h Communication Modem 4G Cat.4 Europe module (LE910-EU V2) Modem antenna Internal WLAN Wifi... -
Page 5: Hardware Description
2. Hardware description 2.1. External view 1 : OBD connector 2 : USB connector 3 : Status led 2.2. Internal view 4 : GNSS antenna 5 : SIM holder 6 : Internal battery* * Please read warnings section at the beginning of the installation guide... -
Page 6: Obd Connector Pin Out
2.3 OBD connector pin out Pin # Comment J1850+ (PWM/VPW) Chassis ground Signal ground CAN High K line J1850- (PWM) CAN low L line Battery voltage Please read warnings section at the beginning of the installation guide 2.4 OBD adapter wires This adapter is only used to connect the OBD to a computer (laptop/desktop). -
Page 7: Preparing/Installing The Device
3. Preparing/installing the device 3.1. Open the device... -
Page 8: Insert/Remove The Sim Card
3.2. Insert/remove the SIM card The SIM card slot is located between the two electronic cards. Insert the card with contact on bottom into the slot and push it as far as it will go. Once inserted the SIM card looks like this:... -
Page 9: Properly Close The Device
3.3. Properly close the device First, check that the electronic card is correctly inserted in the plastic part and that usb port is correctly positioned into the casing. If it’s not inserted proceed as shown below. GOOD NOT GOOD NOT GOOD GOOD... - Page 10 Second, insert the back cover beginning with the bottom. Third, insert the top cover beginning with the back and push on top to clip-on the top cover Finally, place the screw.
-
Page 11: Install The Obd Dongle
3.3. Install the OBD Dongle Connect the OBD Dongle on your vehicle OBD connector. 4. LED sequences The Dongle has a two-coloured LED, green and red. When both colours are brightened, you can see an orange light. Green LED Red LED Sequence Meaning Sequence...
Need help?
Do you have a question about the C4D-4G4EUWBT V6+ and is the answer not in the manual?
Questions and answers