Specifications - Nagano Keiki GC31 Instruction Manual

1. Specifications

Pressure range
(Max. pressure
display digit)
Display range
Max allowable
environment
Applicable liquid
Environment used
Connecting screw *1
Accuracy
Power source
Current consumption
Display
Display cycle
Output
-100 ～ 100 kPa
-100 ～ 500 kPa
0 ～ 1.0 MPa
0 ～ 2.0 MPa
0 ～ 3.5 MPa
0 ～ 5 MPa
0 ～ 10 MPa
0 ～ 20 MPa
0 ～ 35 MPa
0 ～ 50 MPa
From -10 to 110 %F.S. of the pressure range or from -1999 to 1999
Two times of pressure range
1.5 times of pressure range
Air, water, and oil, etc.. (Non-corrosive gas/liquid)
Under normal conditions, do not use a location where flammable or
Explosive gasses or liquids are present.
R1/8 (with M5 female screw) Range: less than 1MPa
R1/4, G1/4B
Display accuracy
Temperature characteristic
12 - 24 VDC ±10% Ripple voltage : 10%(P-P) or lower
Less than 30m ADC (Not including current of comparator output)
Pressure display 3 1/2 digit LED (Height of characters : 10 mm)
Operation display Red LED X 2 (Lit when turned ON)
0.2 s
Comparator output *1
NPN open collector × 2 outputs
PNP open collector × 2 outputs
Response Less than 5 ms
Output NPN
capacity PNP
Dead band. Hysteresis
Window comparator
Delay 0.00～2.00 s (Both ON /OFF)
TY-GC31-004A
-0.1 ～ 1.0 MPa
-0.1 ～ 2.0 MPa
(display value)
(less than 35 MPa)
(35 MPa or higher)
±(1.0 %F.S. + 1 digit) at 23 ℃
±0.1 %F.S./ ℃ (Both zero and span)
30 VDC, 80 mA max.
24 VDC (Range of supply voltage),
80 mA max.
:variable
:1%F.S. Fixed
3/24
(100)
(500)
(1.000)
(2.00)
(3.50)
(5.00)
(10.00)
(20.0)
(35.0)
(50.0)
Rev.B