Cleaning And Maintenance; Disposal And Recycling - EINHELL GC-CT 18/24 Li Operating Instructions Manual

7. Cleaning and maintenance

HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
•
Use a brush to remove deposits from the
safety guard.
7.2 Changing the blade
IMPORTANT! Remove the battery before
replacing blade!
•
To remove the blade, push the blade inwards
and remove it through the larger opening as
shown in Fig. 19.
•
To fit the new blade, proceed in reverse order
(Fig. 7). Make sure that it clicks into place.
7.3 Maintenance
There are no other parts inside the equipment
which require maintenance.

8. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Anl_GC_CT_18_24_Li_USA_SPK7.indb 12 Anl_GC_CT_18_24_Li_USA_SPK7.indb 12
EN
9. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
10. Faults
The equipment does not work:
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to the customer service address
below.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 12 -
23.11.2022 15:01:28 23.11.2022 15:01:28