Table of Contents
Advertisement
Fault
"E:30 / -80"
"E:38 / -25 / -26"
"E:10 / -00 / -10 /
-20"
"H:32"
"E:30 / -10" and/or
Cause and troubleshooting
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 37.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Drain pump is blocked.
→ "Cleaning the drum", Page 42
▶
if the fault is displayed again,
→ "Cleaning the drain pump", Page 44
▶
Inlet opening of the rubber gasket is blocked.
→ "Cleaning the intake opening in the rubber gas-
▶
ket", Page 47
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 43
Switch the appliance on.
3.
If the display appears again after cleaning the
4.
pump unit, or the programme cannot be started,
call customer service.
→ "Customer Service", Page 61
Note: You can deactivate and manually dose the intel-
ligent dosing system until the fault is rectified.
→ "Buttons", Page 24
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
Clean the water inflow filter.
▶
The tap is turned off.
Turn on the tap.
▶
Troubleshooting en
49
Advertisement
Table of Contents
