Table of Contents
Advertisement
5.
Replace the softener cover.
6.
Reinsert the detergent drawer while
pressing down on the middle of the
softener cover.
Cleaning the water supply
filter
Clean the filter if water is not supplied
properly.
1.
Turn the tap off.
2.
Switch on the appliance.
3.
Select the Cotton programme, and
then press the Start button. Drainage
begins when the appliance is started.
4.
After 2 minutes, switch off the
appliance. Water has drained out of
the water supply hose.
5.
Disconnect the water supply hose
from the appliance.
6.
Clean the filter, which is on the rear
of the appliance.
Use a small brush, for example,
a toothbrush.
over
7.
Disconnect the hose from the tap and
then clean the filter on hose in the
same way.
NA-106VC6_English_WHK.indb 29
Maintenance
8.
Reconnect the water supply hose.
Tighten the plastic joint firmly.
9.
Turn on the tap and then check for
leaks.
Preventing a frozen water
supply hose
If the appliance is delivered in freezing
weather conditions, after setting up, leave
it at room temperature for 24 hours before
using. This will ensure that the water
supply hose does not become clogged up
with ice.
If your water supply hose freezes, perform
the following procedures:
1.
Wrap warm towels around the joints
of the water supply hose.
Tap
Joints
Water supply hose
2.
Add 2 to 3 litres of warm water to the
drum.
approximately
50 °C
3.
Run the Drain programme. (P.18.)
Maintenance - 29
2018-8-1 14:07:47
Advertisement
Table of Contents
