Table of Contents
Advertisement
Cleaning the water supply
filter
• Remove the water-supply hose regularly,
and clean out dirt on the filter.
• To prevent water splash, please follow
the following steps before removing the
water-supply hose.
1. Turn the tap off.
2. Press the On button to switch on the
power.
3. Select the Cotton programme, and
then press the Start/Pause button.
4. Switch off the power after 1 minute.
Water has been drained out of the
water-supply hose.
5. Unscrew the water-supply hose and
remove it.
6. Clean the filter, which is on the rear
of the appliance.
Use a small brush, for example, a
toothbrush.
7. Reconnect the water-supply hose,
turn on the tap, and check whether
there is water leak.
Preventing a frozen water
supply hose
If your appliance is delivered in freezing
weather conditions, after installation, leave
it at room temperature for 24 hours before
using. This will ensure that the water-
supply and water-drain hoses and internal
connection hoses are not frozen.
In case of freezing, perform the following
procedures:
1. Wrap hot towels around the joints of
the water-supply hose.
Tap
Joints
2. Add 2 to 3 litres of warm water into
the drum.
3. After waiting for ten or more minutes,
touch the Mode button to run the
Spin process.
Maintenance
Water-supply hose
About
50 °C
Maintenance - 33
Hide quick links:
Advertisement
Table of Contents
