Hardware Overview; Connectors - Axis P7214 User Manual

AXIS P7214 Video Encoder

Hardware Overview

Hardware Overview
1.
Audio input 1
2.
Audio input 2
3.
Audio output 1
4.
Video input connectors
5.
LED indicators for power, status, network
6.
Mounting holes
7.
SD card slot (microSD)
8.
I/O connector
9.
RS-485/RS-422 connector
10. Control button
11. Power connector
12. Network connector (PoE)

Connectors

For technical specifications, see
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).
NOTICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded
network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
for regulatory requirements.
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in amplifier. A stereo connector must be used for audio out.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage.
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
6
5
4
page 50
.
1 2 3 4
IN 1 IN 2 OUT 1
3
2
1
7
4
9 10 11 12
8