AXIS P7214 Video Encoder
Hardware Overview
Hardware Overview
1.
Audio input 1
2.
Audio input 2
3.
Audio output 1
4.
Video input connectors
5.
LED indicators for power, status, network
6.
Mounting holes
7.
SD card slot (microSD)
8.
I/O connector
9.
RS-485/RS-422 connector
10. Control button
11. Power connector
12. Network connector (PoE)
Connectors and Buttons
For technical specifications, see page 56.
BNC Connector
Each video input is terminated using a coax/BNC connector. Connect a 75 Ohm coaxial video cable; the recommended maximum
length is 250 m (800 ft).
Note
75 Ohm video termination can be enabled/disabled for the video input through the product's web page at Video & Audio >
Camera Settings > Video termination. This termination is enabled on factory default. In cases where the product is to be
connected in parallel with other equipment, for optimum video quality, it is recommended that termination be enabled for
only the last device in the video signal chain.
Network Connector
RJ45 Ethernet connector. Supports Power over Ethernet (PoE).
NOTICE
NOTICE
NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network switch
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. For
information about regulatory requirements, see Regulatory Information, on page 2 .
5