Table of Contents
Advertisement
Installation Guidelines
Items Included with each SmartPoint and RoutePoint Wireless Router
Each SmartPoint or RoutePoint wireless router comes with the following items:
•
•
•
•
•
•
•
•
•
Required Tools and Supplies for Installation
You need the following tools and supplies to complete the wireless router installation:
•
•
•
•
•
•
Note
Wall Mounting Instructions
The SmartPoint and RoutePoint wireless routers can be wall mounted in the following three ways:
•
•
•
8
Four 1-inch drywall screws
Four 1-inch drywall anchors
Two right angle mounting brackets
One SmartPoint or RoutePoint wireless router
One AC/DC power converter, for use at 110/120 VAC
Two antennas (optional)
One 0.5 ml capsule of Loctite
Four #6–32 screws - phillips head
Four #6–32 screws - tamper-resistant TORX
Phillips head screwdriver
Drill with 3/16 inch diameter drill bit
Stud finder
Tamper-resistant TORX key driver T10-H (if tamper-resistant TORX screws are used)
A non-switched, 110 Volt 15 Amp duplex power outlet within five feet of the SmartPoint or
RoutePoint wireless router mounting location
A wood or plasterboard wall with adequate clearance to mount the SmartPoint or RoutePoint
wireless router
In order to comply with FCC RF exposure limits, SmartPoint and RoutePoint wireless router
dipole antennas should be located at a minimum distance of 7.9 inches (20cm) or more from
people.
Edge mounted, as shown in Figure 4
Flat mounted, as shown in Figure 5
Secure mounted, as shown in Figure 6
®
Threadlocker 242 (used to bond antenna connectors to unit)
®
T10-H
Advertisement
Table of Contents
