Table of Contents
Advertisement
Operating Your Wireless Router
Operating Your Wireless Router
This section describes the steps required to properly configure your wireless router for use.
Preparing to Access the Configuration Utility
Before you can access the SmartPoint and RoutePoint configuration utility, you must set the IP
address and subnet mask on your computer, as described in the following steps:
Step 1
Figure 11
Step 2
Step 3
14
From the Start button, select Settings → Network and Dial-Up Connections. The
Network and Dial-up Connections folder opens, as shown in Figure 11.
Network and Dial-Up Connections Folder
Right click on the Ethernet interface for your PC, for example 10-Base-T.
Select Properties. The Properties dialog box for your interface opens, as shown in
Figure 12.
Advertisement
Table of Contents
