Table of Contents
Advertisement
Installation Guidelines
Figure 7
Connecting Power and LAN
The LAN port on your SmartPoint or RoutePoint is compatible with IEEE 802.3 af-compliant power
sourcing devices, as shown in Figure 8. If you are using Power Over Ethernet you will not need to
connect a separate power supply.
Note
Figure 8
Note
Follow these steps to connect a SmartPoint or RoutePoint wireless router to your network:
Step 1
12
SmartPoint and RoutePoint Wireless Router Antenna Connectors
Apply 2 drops of Loctite here
When the SmartPoint or RoutePoint wireless router is installed in a plenum or air-handling
space, the cables employed should be suitable under NEC article 800-50 and NFPA 262 and
marked accordingly, for use in plenums and air-handling spaces with regard to smoke
propagation, such as CL2-P, CL3-P, MPP or CMP.
Power Over Ethernet Option
Power injector
(not supplied by FHP)
If you use the Power Over Ethernet option, make sure that the power sourcing device is IEEE
802.3 af-compliant.
Attach a category 5 twisted pair patch cable to the Ethernet port labeled LAN on the
SmartPoint or RoutePoint wireless router as shown in Figure 9.
LAN port
fhp_007
fhp_012
Advertisement
Table of Contents
