Texas Instruments bq24650EVM User Manual

Texas Instruments bq24650EVM User Manual

Synchronous, switch-mode, battery charge controller for solar power
Hide thumbs Also See for bq24650EVM:

Advertisement

Quick Links

bq24650EVM Synchronous, Switch-Mode, Battery Charge
Controller for Solar Power
This user's guide describes the features and operation of the bq24650EVM Evaluation Module (EVM). The
EVM assists users in evaluating the bq24650 synchronous battery charger. The EVM is also called the
HPA639 A. The manual includes the bq24650EVM bill of materials, board layout, and schematic.
1
1.1
1.2
1.3
1.4
1.5
2
2.1
2.2
2.3
2.4
2.5
2.6
2.7
3
4
4.1
1
...................................................................................................................
2
3
.................................................................................................................
4
5
6
7
8
1
2
Control and Key Parameters Settings
3
Recommended Operating Conditions
1

Introduction

1.1

Features

Synchronous switch-mode battery charge controller for solar power
SLUU444A - August 2010 - Revised October 2010
Submit Documentation Feedback
..................................................................................................................
.............................................................................................................
................................................................................................
......................................................................................................
...............................................................................................................
...........................................................................................................
................................................................................................................
...............................................................................................................
..............................................................................................................
...........................................................................................................
...................................................................................................
...........................................................................................................
......................................................................................................
......................................................................................................
..............................................................................................................
...............................................................................................................
..............................................................................................................
..........................................................................................................
.................................................................................................
...............................................................................................................
....................................................................................
....................................................................................
bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for
Copyright © 2010, Texas Instruments Incorporated
SLUU444A - August 2010 - Revised October 2010
Contents
...........................................................................
...........................................................................
.......................................................................
List of Figures
..................................................................
List of Tables
User's Guide
1
1
2
2
3
3
5
5
5
5
5
5
6
7
9
10
11
6
11
12
13
14
15
16
17
2
3
3
1
Solar Power

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the bq24650EVM and is the answer not in the manual?

Questions and answers

Summary of Contents for Texas Instruments bq24650EVM

  • Page 1: Table Of Contents

    Synchronous, Switch-Mode, Battery Charge Controller for Solar Power This user's guide describes the features and operation of the bq24650EVM Evaluation Module (EVM). The EVM assists users in evaluating the bq24650 synchronous battery charger. The EVM is also called the HPA639 A.
  • Page 2: General Description

    Connected to system J2–VOUT Connected to charger output J2–PGND Ground J2–TS Temperature qualification voltage Input bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for SLUU444A – August 2010 – Revised October 2010 Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 3: Control And Key Parameters Settings

    Operating junction temperature range, T °C The bq24650EVM board requires a regulated supply approximately 1 V minimum above the regulated voltage of the battery pack to a maximum input voltage of 28 Vdc. The charge voltage is programmed via a resistor divider from the battery to ground, with the midpoint tied to the VFB pin.
  • Page 4 SRP and SRN is fixed at 40 mV. 40 mV CHARGE It is set at 2 Adc from the factory. bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for SLUU444A – August 2010 – Revised October 2010 Solar Power Submit Documentation Feedback...
  • Page 5: Test Summary

    4. Precautions must be observed to avoid touching areas of the assembly that may get hot or present a shock hazard during testing. Quality 1. Test data can be made available on request from Texas Instruments. Apparel 1. Electrostatic smock 2.
  • Page 6: Equipment Setup

    LEDPWR TEST POINTS SETTINGS Figure 1. Original Test Setup for HPA639 A Evaluation Board bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for SLUU444A – August 2010 – Revised October 2010 Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 7: Procedure

    J2 (SYS, PGND). Resume other status as in Section 2.7.3. (Short JP1, JP4, set LOAD#2 to 10.5 V.) SLUU444A – August 2010 – Revised October 2010 bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 8 Ensure that I(J2(VOUT))= 0 A ±100 mA and → (J2(VSYS)) = 2.4 A ±200 mA. 2.7.7 Test Complete Turn off the power supply, and remove all connections from the unit under test. bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for SLUU444A – August 2010 – Revised October 2010 Solar Power Submit Documentation Feedback...
  • Page 9: Pcb Layout Guideline

    6. Decoupling capacitor(s) for the charger input must be placed close to the Q1A drain and Q1B source. 7. Take the EVM layout for design reference. SLUU444A – August 2010 – Revised October 2010 bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for Solar Power Submit Documentation Feedback...
  • Page 10: Bill Of Materials, Board Layout, And Schematic

    Bumper foot (install after final wash) 0.440 x 0.2 SJ-5303 Shunt, 100-mil, Black 0.100 929950-00 bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for SLUU444A – August 2010 – Revised October 2010 Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 11: Board Layout

    Bill of Materials, Board Layout, and Schematic www.ti.com Board Layout Figure 2. Top Layer SLUU444A – August 2010 – Revised October 2010 bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 12: Second Layer

    Bill of Materials, Board Layout, and Schematic www.ti.com Figure 3. Second Layer bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for SLUU444A – August 2010 – Revised October 2010 Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 13: Third Layer

    Bill of Materials, Board Layout, and Schematic www.ti.com Figure 4. Third Layer SLUU444A – August 2010 – Revised October 2010 bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 14: Bottom Layer

    Bill of Materials, Board Layout, and Schematic www.ti.com Figure 5. Bottom Layer bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for SLUU444A – August 2010 – Revised October 2010 Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 15: Top Assembly

    Bill of Materials, Board Layout, and Schematic www.ti.com Figure 6. Top Assembly SLUU444A – August 2010 – Revised October 2010 bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 16: Bottom Assembly

    Bill of Materials, Board Layout, and Schematic www.ti.com Figure 7. Bottom Assembly bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for SLUU444A – August 2010 – Revised October 2010 Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 17: Bq24650Evm Schematic

    Bill of Materials, Board Layout, and Schematic www.ti.com Schematic Figure 8. bq24650EVM Schematic SLUU444A – August 2010 – Revised October 2010 bq24650EVM Synchronous, Switch-Mode, Battery Charge Controller for Solar Power Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated...
  • Page 18 ADDITIONAL TERMS AND CONDITIONS, WARNINGS, RESTRICTIONS, AND DISCLAIMERS FOR EVALUATION MODULES Texas Instruments Incorporated (TI) markets, sells, and loans all evaluation boards, kits, and/or modules (EVMs) pursuant to, and user expressly acknowledges, represents, and agrees, and takes sole responsibility and risk with respect to, the following: 1.
  • Page 19 RADIO FREQUENCY REGULATORY COMPLIANCE INFORMATION FOR EVALUATION MODULES Texas Instruments Incorporated (TI) evaluation boards, kits, and/or modules (EVMs) and/or accompanying hardware that is marketed, sold, or loaned to users may or may not be subject to radio frequency regulations in specific countries.
  • Page 20 Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2014, Texas Instruments Incorporated spacer Important Notice for Users of EVMs Considered “Radio Frequency Products”...
  • Page 21 IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue.

Table of Contents