Charger Indicator - Toolson 45.136.10 Original Operating Instructions

10. Charger indicator

Charger indicator
Red LED Green LED
Off Flashing
On Off
Off On
Flashing Off
Flashing Flashing
On On
Anl_PRO_AS_12_Li_SPK7.indb 19 Anl_PRO_AS_12_Li_SPK7.indb 19
GB
Explanations and actions
Ready for use
The charger is connected to the mains and is ready for use; there is no
battery pack in the charger
Charging
The charger is charging the battery pack in quick charge mode.
The battery pack is fully charged (charging completed)
Action:
Take the battery pack out of the charger. Disconnect the charger from
the mains supply.
Adapted charging
The charger is in gentle charging mode. For safety reasons the char-
ging is performed less quickly and takes more than 1 hour. The rea-
sons can be:
- The battery pack has not been used for a very long time or an al-
ready fl at battery was further discharged (exhaustive discharge)
- The battery pack temperature is outside the ideal range (between
10° C and 45° C).
Action: Wait for the charging to be completed; you can still continue to
charge the battery pack.
Fault
Charging is no longer possible. The battery pack is defective.
Action: Never charge a defective battery pack. Take the battery pack
out of the charger.
Temperature fault
The battery pack is too hot (e.g. due to direct sunshine) or too cold
(below 0° C).
Action: Remove the battery pack and keep it at room temperature (ap-
prox. 20° C) for one day.
- 19 -
20.05.15 13:26 20.05.15 13:26