Husqvarna 236RS Operator's Manual page 6

• Use a helmet if it is possible that objects fall on your
head.
• Always use approved ear protection while you
operate the product. Noise for a long period can
cause noise-induced hearing loss.
• Make sure that you have a first aid kit near.
Protective devices on the product
• Make sure that you regularly do the maintenance to
the product.
• The life of the product increases.
• The risk of accidents decreases.
Let an approved dealer or an approved service
center regularly examine the product to do
adjustments or repairs.
• Do not use a product with damaged protective
equipment. If the product is damaged, speak to an
approved service center.
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring operates correctly.
B
2. Push down the throttle trigger lockout and make
sure that it goes back to its initial position when you
release it.
6
3. Make sure that the throttle trigger is locked at the
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
A
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
To do a check of the cutting attachment guard
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the engine.
idle position when the throttle trigger lockout is
released.
cutting attachment stops and stays stationary.
WARNING:
attachment moves when the throttle
trigger is in the idle position, then the
carburetor idle speed must be adjusted.
Refer to To adjust the idle speed on
page 20 .
sure that the engine stops.
2255 - 001 - 31.08.2023
If the cutting