Husqvarna 236RS Operator's Manual page 12

10. Connect the stop switch wires (H) with the
connectors from the engine.
H
11. Install the dust cover (J).
12. Install the air filter cover.
To install blades and trimmer heads
WARNING:
guard for the blades. See
page 24 . A damaged guard can cause
injury.
WARNING:
with a grass blade, first install the correct
handlebar, blade guard and harness .
WARNING:
blades correctly, it can cause injury.
1. Make sure that the lifted section on the drive disc/
support flange engages correctly in the center hole
of the blades.
12
J
Only use the approved
Accessories on
If you operate the product
If you do not install the the
2. Install the blades.
To install a blade guard and grass blade
CAUTION:
Only use the approved
guard for the blades. Refer to
on page 24 .
1. Attach the blade guard/cutting attachment guard (A)
onto the shaft and tighten with the bolt (L).
L
A
2. Install the drive disc (B) on the output shaft.
C
A
3. Turn the output shaft until 1 of the holes in the drive
disc aligns with the related hole in the gear housing.
4. Put the locking pin or the hex key (C) in the hole to
lock the shaft.
5. Put the blade (D), support flange (G) and support
cup (F) on the output shaft.
Accessories
A
E
F
G
D
B
2255 - 001 - 31.08.2023