Husqvarna 525iHE3 Operator's Manual page 14

4. Push the release buttons on the battery and pull the
battery out.
To adjust the angle of the cutting unit
The cutting unit can be adjusted in 10 different positions.
WARNING:
unit when you adjust the angle.
1. Stop the product.
2. Pull down the position adjustment handle.
3. Tilt the cutting unit to the correct position. Use 1 of
the procedures that follow.
a) Use the handle.
14
Do not operate the cutting
b) Push the end of the cutting unit against a stable
surface.
4. Release the position adjustment handle to lock the
cutting unit.
5. Push the cutting unit against the hedge to make sure
that it is locked.
To adjust the friction for angle adjustment
WARNING:
unit when you adjust the friction.
1. Stop the product.
2. Install the transport guard on the cutting unit
3. Pull down the position adjustment handle.
4. Tilt the cutting unit to the applicable position.
5. Adjust the screw to set the friction.
6. Set the cutting unit in different positions to try the
friction.
To set the product in transport position
WARNING:
when the product is in transport position.
1. Stop the product.
2. Install the transport guard on the cutting unit.
3. Pull down the position adjustment handle.
Do not operate the cutting
Do not start the product
2130 - 002 - 24.11.2023